FAQ: Where Is The Front Infrared Sensor On The Cisco Explorer 8642Hdc Cable Box Located?

The infrared sensor for the remote is located just to the right of the USB port on the front of the box.

Where is the IR sensor on cisco 8742?

To the right of the USB port.

How do I restart Explorer 8640hdc?

Press stop 3 times on the remote and it will reboot [the “LED” circle going around, or “boot” appears].

How do I reset my Cisco Explorer 8652hdc?

If Trio, hold in “SELECT” key on remote until power icon LED on front panel starts to blink (about 5-10 seconds), release and press up arrow on remote (just above select key.) To re-boot, scroll down to ” REBOOT STB ” on far left, or just disconnect power for about a minute.

How many tuners does a Cisco 8742 have?

The 8742 is a 2-tuner DVR.

Where is the IR sensor on Spectrum cable box?

The IR Receiver is located on the front panel of the Set Top behind the dark plastic cover.

What is the code for a Cisco cable box?

Enter one of the programming code from the list 0498 0497 0506 0535 0512 0466 for your CISCO Cable device.

You might be interested:  Often asked: What Wavelength Of Infrared Do You Need To See In The Dark?

Why is my Cisco cable box not working?

Reset (power cycle) your receiver by unplugging the power cord from the back of the box. Wait 15 seconds and then plug the power cord back in. Wait up to 20 minutes for the receiver to fully recover and turn it back on.

How do you reset a Cisco cable box?

How do you reset a Cisco junction box?

  1. Disconnect power from the junction box by pulling it out of the socket or the back of the box.
  2. Wait 30 seconds.
  3. Reconnect the power cord to the cable box.
  4. Wait 3 to 5 minutes for the box to reset.
  5. Turn on the TV and the decoder.

How do I reset my Rogers PVR?

From Device Settings

  1. Press the Rogers button on your Voice Remote to open the main menu.
  2. Select Settings (the gear icon).
  3. Select Device Settings.
  4. Select Power Preferences.
  5. Select Restart.
  6. Select Restart again to confirm.

What is Cisco DVR?

The HD-DVR and gateway devices are connected using Internet Protocol (IP) and Multimedia over Coax Alliance (MoCA) technology to minimize the need for new wiring in the home. With tru2way, consumers can experience a more interactive TV experience.

How do I program my Cisco Spectrum remote?

Cisco Remote Programming

  1. Locate the Manufacturer and codes from the list provided.
  2. Turn on the TV.
  3. On the Remote, press and hold the TV button.
  4. On the Remote, press and hold the OK button.
  5. Release both keys at the same time.
  6. Enter a four digit number matching the TV Manufacturer from the list provided.
  7. Test remote functions.

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to Top